Steel Cable Tray Specifications and Dimensions Table

Steel cable trays are available in ladder, solid-bottom, and channel types, with widths from 50 mm to 1000 mm, depths from 25 mm to 300 mm, and lengths typically 2–6 meters, conforming to ASTM, NEMA, and NEC standards.

Types of Steel Cable Trays

Ladder Type: Consists of two longitudinal side rails with transverse rungs welded at intervals, typically 6, 9, or 12 inches apart, providing maximum ventilation and support for heavy power cables.

Solid-

Bottom Type: Features a continuous steel sheet welded to side rails, offering added protection for sensitive cables. Channel Type: U-shaped or C-shaped trays suitable for smaller cable runs or support of single circuits. Material StandardsPre-Galvanized Steel: Structural quality steel, mill galvanized per ASTM A653 G90, with covers hot-dip galvanized after fabrication.

Stainless Steel: AISI Type 304 or 316, with rungs welded using Type 316 welding wire for corrosion resistance. Coatings: Hot-dip galvanization (ASTM A123) or electrodeposited zinc (ASTM B633) for durability and corrosion protection.

Dimensions

Width: 50 mm to 1000 mm (2–36 inches), with narrow trays (100–150 mm) for instrumentation, medium trays (300–600 mm) for general power distribution, and wide trays (>600 mm) for industrial or data center applications. Depth (Height): Typically 25 mm to 300 mm, measured from tray bottom to top of side rails. Length: Standard straight sections are 2–6 meters (6–20 feet), with some series limited to shorter lengths depending on load rating.

Rung Spacing: Ladder trays usually have rungs spaced 6, 9, or 12 inches on center, with maximum open spacing not exceeding 102 mm (4 inches) parallel to side rails.

Load and Installation Considerations

Load Ratings: Determined by NEMA/CSA classifications, with deflection measured at midpoint; ventilated trays are preferred for CSA Class C/NEMA 8C or lower loads. Cable Fill: NEC and international codes recommend maximum 50% fill for power cables in a single layer, with 25–40% spare capacity for future expansion. Supports and Accessories: Include bends, tees, elbows, drop-outs, covers, and splice plates, all fabricated to match tray material and coating standards.

Environmental and Safety Considerations

Select tray material based on environmental exposure (corrosive, wet, or outdoor conditions) and electrical insulation requirements. Ensure compliance with ANSI/NFPA 70 (NEC), NEMA VE 1, and relevant ASTM standards for steel quality and galvanization. By understanding these specifications, engineers and installers can select the appropriate steel cable tray system to ensure structural integrity, cable protection, and compliance with electrical codes.